Piston clip installation tool for C-shaped circlips on your moped, moped and small motorcycle.
This tool enables the installation of 10 mm piston pin circlips without eyelets, also known as C-clips, without causing damage to the piston or causing them to fly off.
The locking clip is first inserted into the conical part (bushing) of the tool from behind. The pin is then attached and held against the bore of the piston pin on the piston. The long cylinder can then be carefully pressed into the groove. The use of some lubricant can be helpful.
The suitable alternative for 12 mm KoBo retaining clips can be found in the accessories section.
Quality product from the manufacturer Naraku.
| Manufacturer | Naraku |
| Area of application | (Dis)assembly tool |
| Material | Steel |
| Surface | burnished |
| Diameter | 10 mm |
| Total length | 134 mm |
| Ø Pin | 4.5 mm |
Ratings
Accessories & related products
Explore categories from Tools
Moped fans also bought
Speedometer drive 16" left with lubrication hole
Place of use: left · Ø axle: 11 mm · Material: Aluminum · Color: gray · Wheel size: 16 " · 4-edge speedometer cable: 1.8 mm · Ø mounting hole: 11.2 mm · Ø outside: 42 mm · Overall width outside: 48 mm · Thread type: MF10x1 (fine pitch thread) · Total height: 52 mm
EUR 26.40
Hot 
swiing® ingenious "Expert" motor stand
Total length: 370 mm · Manufacturer: swiing® ingenious parts · Material: Steel · Surface: varnished · Color: red · Color: white · Width: 245 mm · Height: 340 mm · Ø Receptacle: 25 mm · Ø Receptacle: 35 mm · Hole spacing: 21.5 mm · Area of application: Motor bracket · Material thickness: 3.5 mm
EUR 90.30
Attention: new opening hours from 16.02.2026 & new evening sale on Thursday 17:30-20:00
